![]() ![]() The thermostat can automatically re-adjust its clock at Daylight Savings Time changeover. Press the Min button to set the minutes.The temperature adjustment buttons only allow you to view the temperature setpoint. Select 15 seconds for better temperature control in most other cases.Ĭ. The word FAN is displayed when this setting is selected. You must select 5 minutes if you have a fan-forced heater. The thermostat re-assesses the start time daily based on the previous day’s performance.ī. When this function is enabled, the thermostat calculates the optimal time to start heating in order to obtain the desired temperature by the set time. Early Start can be used in Automatic mode only. SW1 Early Start a Off On SW2 Display format ☌ / 24-hour ☏ / 12-hour SW3 Cycle length b 15 seconds Baseboard heater 5 minutes Fan-forced heater SW4 Keypad lock c Off OnĪ. The factory settings are indicated by the gray cells in the following table. The configuration switches are on the back of the thermostat. NOTE: If necessary, before re-installing the front component, configure the thermostat (see section 3). Push any excess wire back into the electrical box.Connect the thermostat wires to the line wires and to the load wires using solderless connectors for copper wires.NOTE: Always keep the thermostat’s vents clean and unobstructed. The thermostat wires are not polarized either wire can be connected to the load or to the power supply. #Mitsubishi programmable thermostat install#
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |